CVE-2026-89945

CVE-2026-89945

(In the Linux kernel, the following vulnerability has been resolved: A ...)

CVE-2026-89945

In the Linux kernel, the following vulnerability has been resolved: ASoC: cs35l34: drain threaded IRQ before runtime suspend cs35l34_runtime_suspend() currently switches the codec into regcache_cache_only(true), asserts reset low, and powers the device off without first quiescing the threaded IRQ registered by devm_request_threaded_irq(). That leaves a window where cs35l34_irq_thread() can still run after suspend has removed live hardware access. A running system can reach this during runtime PM while the driver still has critical fault IRQs unmasked. If the threaded handler runs in that window, it reads volatile INT_STATUS_1..4 after cache_only has been enabled, ignores the regmap_read() failures, and can still execute the PROT_RELEASE_CTL release sequence or the BST fault power-down writes. Use disable_irq() before entering cache_only/reset-low/power-off so any in-flight threaded handler is drained and no new IRQ thread can run while the device is suspended. Re-enable the IRQ onl

CVE-2026-89945

In the Linux kernel, the following vulnerability has been resolved: A ...

GHSA-w3mv-pmf4-r863

In the Linux kernel, the following vulnerability has been resolved: ASoC: cs35l34: drain threaded IRQ before runtime suspend cs35l34_runtime_suspend() currently switches the codec into regcache_cache_only(true), asserts reset low, and powers the device off without first quiescing the threaded IRQ registered by devm_request_threaded_irq(). That leaves a window where cs35l34_irq_thread() can still run after suspend has removed live hardware access. A running system can reach this during runtime PM while the driver still has critical fault IRQs unmasked. If the threaded handler runs in that window, it reads volatile INT_STATUS_1..4 after cache_only has been enabled, ignores the regmap_read() failures, and can still execute the PROT_RELEASE_CTL release sequence or the BST fault power-down writes. Use disable_irq() before entering cache_only/reset-low/power-off so any in-flight threaded handler is drained and no new IRQ thread can run while the device is suspended. Re-enable the IRQ ...