Описание
In the Linux kernel, the following vulnerability has been resolved:
scsi: pm80xx: Fix array-index-out-of-of-bounds on rmmod
Since commit f7b705c238d1 ("scsi: pm80xx: Set phy_attached to zero when
device is gone") UBSAN reports:
UBSAN: array-index-out-of-bounds in drivers/scsi/pm8001/pm8001_sas.c:786:17
index 28 is out of range for type 'pm8001_phy [16]'
on rmmod when using an expander.
For a direct attached device, attached_phy contains the local phy id.
For a device behind an expander, attached_phy contains the remote phy
id, not the local phy id.
I.e. while pm8001_ha will have pm8001_ha->chip->n_phy local phys, for a
device behind an expander, attached_phy can be much larger than
pm8001_ha->chip->n_phy (depending on the amount of phys of the
expander).
E.g. on my system pm8001_ha has 8 phys with phy ids 0-7. One of the
ports has an expander connected. The expander has 31 phys with phy ids
0-30.
The pm8001_ha->phy array only contains the phys of the HBA. It does not
contain the phys of the expander. Thus, it is wrong to use attached_phy
to index the pm8001_ha->phy array for a device behind an expander.
Thus, we can only clear phy_attached for devices that are directly
attached.
A flaw was found in the Linux kernel’s pm8001_sas driver (SCSI: pm80xx). When unloading (rmmod) a device behind an expander, the code uses attached_phy (which may refer to a remote phy id) to index into the pm8001_ha->phy array, but the array only has entries for local phys. This out-of-bounds indexing is reported by UBSAN, which may lead to undefined behavior.
Отчет
A moderate severity flaw was found in the Linux kernel PM80xx SAS/SCSI driver (pm8001_sas). When the pm80xx driver module is unloaded (rmmod) on a system where a SAS device is connected through an expander, the driver used the attached_phy value - which for a device behind an expander holds the remote expander phy id - to index the pm8001_ha->phy array, which only contains entries for the HBA's local phys. Because an expander can have more phys than the HBA, this results in an out-of-bounds array access (reported by UBSAN) that may lead to undefined behavior in the kernel at module unload time. Triggering the issue requires local privileged access to unload the kernel module together with the specific hardware configuration of a SAS expander connected to the HBA. Red Hat assessed the impact as moderate (CVSS 3.1 score 5.8), lower than the CVE.org severity of 7.8 (Important), due to the high attack complexity, the local privileges required, and the limited confidentiality and integrity impact of this unload-time out-of-bounds access. No Red Hat product is currently affected: Red Hat Enterprise Linux 7 through 10 (kernel and kernel-rt) and Red Hat In-Vehicle OS 1.1 are marked not affected because the vulnerable code is not present in the shipped kernels, and Red Hat Enterprise Linux 6 Extended Lifecycle Support is out of support scope for this issue.
Меры по смягчению последствий
Mitigation for this issue is either not available or the currently available options don't meet the Red Hat Product Security criteria comprising ease of use and deployment, applicability to widespread installation base or stability.
Затронутые пакеты
| Платформа | Пакет | Состояние | Рекомендация | Релиз |
|---|---|---|---|---|
| Red Hat Enterprise Linux 10 | kernel | Not affected | ||
| Red Hat Enterprise Linux 6 | kernel | Out of support scope | ||
| Red Hat Enterprise Linux 7 | kernel | Not affected | ||
| Red Hat Enterprise Linux 7 | kernel-rt | Not affected | ||
| Red Hat Enterprise Linux 8 | kernel | Not affected | ||
| Red Hat Enterprise Linux 8 | kernel-rt | Not affected | ||
| Red Hat Enterprise Linux 9 | kernel | Not affected | ||
| Red Hat Enterprise Linux 9 | kernel-rt | Not affected |
Показывать по
Дополнительная информация
Статус:
EPSS
5.8 Medium
CVSS3
Связанные уязвимости
In the Linux kernel, the following vulnerability has been resolved: scsi: pm80xx: Fix array-index-out-of-of-bounds on rmmod Since commit f7b705c238d1 ("scsi: pm80xx: Set phy_attached to zero when device is gone") UBSAN reports: UBSAN: array-index-out-of-bounds in drivers/scsi/pm8001/pm8001_sas.c:786:17 index 28 is out of range for type 'pm8001_phy [16]' on rmmod when using an expander. For a direct attached device, attached_phy contains the local phy id. For a device behind an expander, attached_phy contains the remote phy id, not the local phy id. I.e. while pm8001_ha will have pm8001_ha->chip->n_phy local phys, for a device behind an expander, attached_phy can be much larger than pm8001_ha->chip->n_phy (depending on the amount of phys of the expander). E.g. on my system pm8001_ha has 8 phys with phy ids 0-7. One of the ports has an expander connected. The expander has 31 phys with phy ids 0-30. The pm8001_ha->phy array only contains the phys of the HBA. It does not contain the ...
In the Linux kernel, the following vulnerability has been resolved: scsi: pm80xx: Fix array-index-out-of-of-bounds on rmmod Since commit f7b705c238d1 ("scsi: pm80xx: Set phy_attached to zero when device is gone") UBSAN reports: UBSAN: array-index-out-of-bounds in drivers/scsi/pm8001/pm8001_sas.c:786:17 index 28 is out of range for type 'pm8001_phy [16]' on rmmod when using an expander. For a direct attached device, attached_phy contains the local phy id. For a device behind an expander, attached_phy contains the remote phy id, not the local phy id. I.e. while pm8001_ha will have pm8001_ha->chip->n_phy local phys, for a device behind an expander, attached_phy can be much larger than pm8001_ha->chip->n_phy (depending on the amount of phys of the expander). E.g. on my system pm8001_ha has 8 phys with phy ids 0-7. One of the ports has an expander connected. The expander has 31 phys with phy ids 0-30. The pm8001_ha->phy array only contains the phys of the HBA. It does not con
In the Linux kernel, the following vulnerability has been resolved: s ...
In the Linux kernel, the following vulnerability has been resolved: scsi: pm80xx: Fix array-index-out-of-of-bounds on rmmod Since commit f7b705c238d1 ("scsi: pm80xx: Set phy_attached to zero when device is gone") UBSAN reports: UBSAN: array-index-out-of-bounds in drivers/scsi/pm8001/pm8001_sas.c:786:17 index 28 is out of range for type 'pm8001_phy [16]' on rmmod when using an expander. For a direct attached device, attached_phy contains the local phy id. For a device behind an expander, attached_phy contains the remote phy id, not the local phy id. I.e. while pm8001_ha will have pm8001_ha->chip->n_phy local phys, for a device behind an expander, attached_phy can be much larger than pm8001_ha->chip->n_phy (depending on the amount of phys of the expander). E.g. on my system pm8001_ha has 8 phys with phy ids 0-7. One of the ports has an expander connected. The expander has 31 phys with phy ids 0-30. The pm8001_ha->phy array only contains the phys of the HBA. It does not ...
Уязвимость компонента drivers/scsi/pm8001 ядра операционной системы Linux, позволяющая нарушителю получить доступ к конфиденциальным данным, нарушить их целостность, а также вызвать отказ в обслуживании
EPSS
5.8 Medium
CVSS3