Описание
In the Linux kernel, the following vulnerability has been resolved:
xfrm: ah: account for ESN high bits in async callbacks
AH allocates its temporary auth/ICV layout differently when ESN is enabled:
the async ahash setup appends a 4-byte seqhi slot before the ICV or
auth_data area, but the async completion callbacks still reconstruct the
temporary layout as if seqhi were absent.
With an async AH implementation selected, that makes AH copy or compare
the wrong bytes on both the IPv4 and IPv6 paths. In UML repro on IPv4 AH
with ESN and forced async hmac(sha1), ping fails with 100% packet loss,
and the callback logs show the pre-fix drift:
ah4 output_done: esn=1 err=0 icv_off=20 expected_off=24
ah4 input_done: esn=1 auth_off=20 expected_auth_off=24 icv_off=32 expected_icv_off=36
Reconstruct the callback-side layout the same way the setup path built it
by skipping the ESN seqhi slot before locating the saved auth_data or ICV.
Per RFC 4302, the ESN high-order 32 bits participate in the AH ICV
computation, so the async callbacks must account for the seqhi slot.
Post-fix, the same IPv4 AH+ESN+forced-async-hmac(sha1) UML repro shows
the corrected offset (ah4 output_done: esn=1 err=0 icv_off=24
expected_off=24) and ping succeeds; net/ipv4/ah4.o and net/ipv6/ah6.o
build clean at W=1. IPv6 AH+ESN was not exercised at runtime, and the
change has not been tested against a real async hardware AH engine.
A flaw was found in the Linux kernel's xfrm: ah component, which handles network security protocols. When Extended Sequence Number (ESN) is active, the kernel incorrectly processes parts of network packet data during security checks. This error can lead to the system dropping legitimate network traffic. An attacker could potentially exploit this to cause a Denial of Service (DoS), making the affected system unable to communicate over the network.
Затронутые пакеты
| Платформа | Пакет | Состояние | Рекомендация | Релиз |
|---|---|---|---|---|
| Red Hat Enterprise Linux 10 | kernel | Affected | ||
| Red Hat Enterprise Linux 6 | kernel | Out of support scope | ||
| Red Hat Enterprise Linux 7 | kernel | Affected | ||
| Red Hat Enterprise Linux 7 | kernel-rt | Affected | ||
| Red Hat Enterprise Linux 8 | kernel | Affected | ||
| Red Hat Enterprise Linux 8 | kernel-rt | Affected | ||
| Red Hat Enterprise Linux 9 | kernel | Affected | ||
| Red Hat Enterprise Linux 9 | kernel-rt | Affected |
Показывать по
Дополнительная информация
Статус:
EPSS
7 High
CVSS3
Связанные уязвимости
In the Linux kernel, the following vulnerability has been resolved: xfrm: ah: account for ESN high bits in async callbacks AH allocates its temporary auth/ICV layout differently when ESN is enabled: the async ahash setup appends a 4-byte seqhi slot before the ICV or auth_data area, but the async completion callbacks still reconstruct the temporary layout as if seqhi were absent. With an async AH implementation selected, that makes AH copy or compare the wrong bytes on both the IPv4 and IPv6 paths. In UML repro on IPv4 AH with ESN and forced async hmac(sha1), ping fails with 100% packet loss, and the callback logs show the pre-fix drift: ah4 output_done: esn=1 err=0 icv_off=20 expected_off=24 ah4 input_done: esn=1 auth_off=20 expected_auth_off=24 icv_off=32 expected_icv_off=36 Reconstruct the callback-side layout the same way the setup path built it by skipping the ESN seqhi slot before locating the saved auth_data or ICV. Per RFC 4302, the ESN high-order 32 bits participate in the A...
In the Linux kernel, the following vulnerability has been resolved: xfrm: ah: account for ESN high bits in async callbacks AH allocates its temporary auth/ICV layout differently when ESN is enabled: the async ahash setup appends a 4-byte seqhi slot before the ICV or auth_data area, but the async completion callbacks still reconstruct the temporary layout as if seqhi were absent. With an async AH implementation selected, that makes AH copy or compare the wrong bytes on both the IPv4 and IPv6 paths. In UML repro on IPv4 AH with ESN and forced async hmac(sha1), ping fails with 100% packet loss, and the callback logs show the pre-fix drift: ah4 output_done: esn=1 err=0 icv_off=20 expected_off=24 ah4 input_done: esn=1 auth_off=20 expected_auth_off=24 icv_off=32 expected_icv_off=36 Reconstruct the callback-side layout the same way the setup path built it by skipping the ESN seqhi slot before locating the saved auth_data or ICV. Per RFC 4302, the ESN high-order 32 bits participate in
xfrm: ah: account for ESN high bits in async callbacks
In the Linux kernel, the following vulnerability has been resolved: x ...
In the Linux kernel, the following vulnerability has been resolved: xfrm: ah: account for ESN high bits in async callbacks AH allocates its temporary auth/ICV layout differently when ESN is enabled: the async ahash setup appends a 4-byte seqhi slot before the ICV or auth_data area, but the async completion callbacks still reconstruct the temporary layout as if seqhi were absent. With an async AH implementation selected, that makes AH copy or compare the wrong bytes on both the IPv4 and IPv6 paths. In UML repro on IPv4 AH with ESN and forced async hmac(sha1), ping fails with 100% packet loss, and the callback logs show the pre-fix drift: ah4 output_done: esn=1 err=0 icv_off=20 expected_off=24 ah4 input_done: esn=1 auth_off=20 expected_auth_off=24 icv_off=32 expected_icv_off=36 Reconstruct the callback-side layout the same way the setup path built it by skipping the ESN seqhi slot before locating the saved auth_data or ICV. Per RFC 4302, the ESN high-order 32 bits participate...
EPSS
7 High
CVSS3