Описание
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: ucsi: validate connector number in ucsi_connector_change()
The connector number in a UCSI CCI notification is a 7-bit field
supplied by the PPM. ucsi_connector_change() uses it to index the
ucsi->connector[] array without checking it against the number of
connectors the PPM reported at init time, so a buggy or malicious PPM
(EC firmware, or an I2C-attached UCSI controller on the ccg / stm32g0 /
glink transports) can drive schedule_work() on memory past the end of
the array.
Reject connector numbers that are zero or exceed cap.num_connectors
before dereferencing the array.
A flaw was found in the Linux kernel's USB Type-C subsystem. This vulnerability allows a malicious or buggy Power Delivery Microcontroller (PPM), such as embedded controller (EC) firmware or an I2C-attached Universal Serial Bus (USB) Type-C Connector System Interface (UCSI) controller, to provide an invalid connector number. This invalid number is then used to access memory beyond the intended array boundaries, which can lead to a system crash. The primary consequence is a denial of service, making the system unavailable.
Дополнительная информация
Статус:
EPSS
7 High
CVSS3
Связанные уязвимости
In the Linux kernel, the following vulnerability has been resolved: usb: typec: ucsi: validate connector number in ucsi_connector_change() The connector number in a UCSI CCI notification is a 7-bit field supplied by the PPM. ucsi_connector_change() uses it to index the ucsi->connector[] array without checking it against the number of connectors the PPM reported at init time, so a buggy or malicious PPM (EC firmware, or an I2C-attached UCSI controller on the ccg / stm32g0 / glink transports) can drive schedule_work() on memory past the end of the array. Reject connector numbers that are zero or exceed cap.num_connectors before dereferencing the array.
In the Linux kernel, the following vulnerability has been resolved: usb: typec: ucsi: validate connector number in ucsi_connector_change() The connector number in a UCSI CCI notification is a 7-bit field supplied by the PPM. ucsi_connector_change() uses it to index the ucsi->connector[] array without checking it against the number of connectors the PPM reported at init time, so a buggy or malicious PPM (EC firmware, or an I2C-attached UCSI controller on the ccg / stm32g0 / glink transports) can drive schedule_work() on memory past the end of the array. Reject connector numbers that are zero or exceed cap.num_connectors before dereferencing the array.
usb: typec: ucsi: validate connector number in ucsi_connector_change()
In the Linux kernel, the following vulnerability has been resolved: u ...
In the Linux kernel, the following vulnerability has been resolved: usb: typec: ucsi: validate connector number in ucsi_connector_change() The connector number in a UCSI CCI notification is a 7-bit field supplied by the PPM. ucsi_connector_change() uses it to index the ucsi->connector[] array without checking it against the number of connectors the PPM reported at init time, so a buggy or malicious PPM (EC firmware, or an I2C-attached UCSI controller on the ccg / stm32g0 / glink transports) can drive schedule_work() on memory past the end of the array. Reject connector numbers that are zero or exceed cap.num_connectors before dereferencing the array.
EPSS
7 High
CVSS3