Описание
In the Linux kernel, the following vulnerability has been resolved:
iio: accel: bmc150: clamp the device-reported FIFO frame count
__bmc150_accel_fifo_flush() copies the number of samples the device
reports in its hardware FIFO into an on-stack buffer
u16 buffer[BMC150_ACCEL_FIFO_LENGTH * 3];
which is sized for at most BMC150_ACCEL_FIFO_LENGTH (32) samples. The
frame count is read from the FIFO_STATUS register and only masked to its
7 valid bits:
count = val & 0x7F;
so it can be 0..127. The only other limit applied to it is the optional
caller-supplied sample budget:
if (samples && count > samples)
count = samples;
which does not constrain count on the flush-all path (samples == 0), and
leaves it well above 32 whenever samples is larger. count samples are
then transferred into buffer[]:
bmc150_accel_fifo_transfer(data, (u8 *)buffer, count);
bmc150_accel_fifo_transfer() reads count * 6 bytes through regmap, so a
malfunctioning, malicious or counterfeit accelerometer (or an attacker
tampering with the I2C/SPI bus) that reports up to 127 frames writes up
to 762 bytes into the 192-byte buffer: a stack out-of-bounds write of up
to 570 bytes that clobbers the stack canary, saved registers and the
return address.
Clamp count to BMC150_ACCEL_FIFO_LENGTH, the number of samples buffer[]
is sized for, before the transfer, mirroring the watermark clamp already
done in bmc150_accel_set_watermark(). A well-formed flush reports at most
BMC150_ACCEL_FIFO_LENGTH frames, so legitimate devices are unaffected.
A flaw was found in the Linux kernel's bmc150 accelerometer driver. A malicious or malfunctioning accelerometer device, or an attacker tampering with the I2C/SPI bus, can report an excessively large number of FIFO frames. This improper handling of the frame count leads to a stack out-of-bounds write, which could allow for arbitrary code execution or a denial of service (DoS) on the affected system.
Затронутые пакеты
| Платформа | Пакет | Состояние | Рекомендация | Релиз |
|---|---|---|---|---|
| Red Hat Enterprise Linux 10 | kernel | Not affected | ||
| Red Hat Enterprise Linux 6 | kernel | Not affected | ||
| Red Hat Enterprise Linux 7 | kernel | Not affected | ||
| Red Hat Enterprise Linux 7 | kernel-rt | Not affected | ||
| Red Hat Enterprise Linux 8 | kernel | Not affected | ||
| Red Hat Enterprise Linux 8 | kernel-rt | Not affected | ||
| Red Hat Enterprise Linux 9 | kernel | Not affected | ||
| Red Hat Enterprise Linux 9 | kernel-rt | Not affected |
Показывать по
Дополнительная информация
EPSS
Связанные уязвимости
In the Linux kernel, the following vulnerability has been resolved: iio: accel: bmc150: clamp the device-reported FIFO frame count __bmc150_accel_fifo_flush() copies the number of samples the device reports in its hardware FIFO into an on-stack buffer u16 buffer[BMC150_ACCEL_FIFO_LENGTH * 3]; which is sized for at most BMC150_ACCEL_FIFO_LENGTH (32) samples. The frame count is read from the FIFO_STATUS register and only masked to its 7 valid bits: count = val & 0x7F; so it can be 0..127. The only other limit applied to it is the optional caller-supplied sample budget: if (samples && count > samples) count = samples; which does not constrain count on the flush-all path (samples == 0), and leaves it well above 32 whenever samples is larger. count samples are then transferred into buffer[]: bmc150_accel_fifo_transfer(data, (u8 *)buffer, count); bmc150_accel_fifo_transfer() reads count * 6 bytes through regmap, so a malfunctioning, malicious or counterfeit accelerometer (or an attacker t...
In the Linux kernel, the following vulnerability has been resolved: iio: accel: bmc150: clamp the device-reported FIFO frame count __bmc150_accel_fifo_flush() copies the number of samples the device reports in its hardware FIFO into an on-stack buffer u16 buffer[BMC150_ACCEL_FIFO_LENGTH * 3]; which is sized for at most BMC150_ACCEL_FIFO_LENGTH (32) samples. The frame count is read from the FIFO_STATUS register and only masked to its 7 valid bits: count = val & 0x7F; so it can be 0..127. The only other limit applied to it is the optional caller-supplied sample budget: if (samples && count > samples) count = samples; which does not constrain count on the flush-all path (samples == 0), and leaves it well above 32 whenever samples is larger. count samples are then transferred into buffer[]: bmc150_accel_fifo_transfer(data, (u8 *)buffer, count); bmc150_accel_fifo_transfer() reads count * 6 bytes through regmap, so a malfunctioning, malicious or counterfeit accelerometer (or
In the Linux kernel, the following vulnerability has been resolved: i ...
EPSS