Описание
In the Linux kernel, the following vulnerability has been resolved:
w1: ds28e17: reject an oversize length on an I2C block read
w1_f19_i2c_master_transfer() is the master_xfer for the DS28E17 1-Wire
to I2C bridge. On an I2C_M_RECV_LEN read, it takes the length from the
device. The downstream slave puts a length byte in buf[0]. The driver
then reads that many bytes into buf[1] with w1_f19_i2c_read().
buf[0] is controlled by the device and can be 0 to 255.
w1_f19_i2c_read() only rejects a zero count. The caller buffer is
I2C_SMBUS_BLOCK_MAX + 2, so 34 bytes. A length above 32 makes the read
run past it, up to about 222 bytes out of bounds.
The SMBus core does check buf[0] against I2C_SMBUS_BLOCK_MAX. That
check runs after master_xfer returns. By then the write is already
done. i2c-algo-bit rejects an oversize length before it copies, and
returns -EPROTO.
Reject a length above I2C_SMBUS_BLOCK_MAX at both RECV_LEN sites, the
same way i2c-algo-bit does.
A flaw was found in the Linux kernel's w1: ds28e17 1-Wire to I2C bridge driver. A malicious I2C slave device can provide an oversized length during an I2C block read operation. This causes the driver to read beyond the allocated buffer, leading to an out-of-bounds read of up to 222 bytes. This vulnerability could allow a local attacker to disclose sensitive information or cause a denial of service.
Затронутые пакеты
| Платформа | Пакет | Состояние | Рекомендация | Релиз |
|---|---|---|---|---|
| Red Hat Enterprise Linux 10 | kernel | Not affected | ||
| Red Hat Enterprise Linux 10 | kernel-rt | Not affected | ||
| Red Hat Enterprise Linux 6 | kernel | Not affected | ||
| Red Hat Enterprise Linux 7 | kernel | Not affected | ||
| Red Hat Enterprise Linux 7 | kernel-rt | Not affected | ||
| Red Hat Enterprise Linux 8 | kernel | Not affected | ||
| Red Hat Enterprise Linux 8 | kernel-rt | Not affected | ||
| Red Hat Enterprise Linux 9 | kernel | Not affected | ||
| Red Hat Enterprise Linux 9 | kernel-rt | Not affected | ||
| Red Hat OpenShift Container Platform 4 | openshift/ose-rhel-coreos-8 | Not affected |
Показывать по
Дополнительная информация
Статус:
EPSS
5.5 Medium
CVSS3
Связанные уязвимости
In the Linux kernel, the following vulnerability has been resolved: w1: ds28e17: reject an oversize length on an I2C block read w1_f19_i2c_master_transfer() is the master_xfer for the DS28E17 1-Wire to I2C bridge. On an I2C_M_RECV_LEN read, it takes the length from the device. The downstream slave puts a length byte in buf[0]. The driver then reads that many bytes into buf[1] with w1_f19_i2c_read(). buf[0] is controlled by the device and can be 0 to 255. w1_f19_i2c_read() only rejects a zero count. The caller buffer is I2C_SMBUS_BLOCK_MAX + 2, so 34 bytes. A length above 32 makes the read run past it, up to about 222 bytes out of bounds. The SMBus core does check buf[0] against I2C_SMBUS_BLOCK_MAX. That check runs after master_xfer returns. By then the write is already done. i2c-algo-bit rejects an oversize length before it copies, and returns -EPROTO. Reject a length above I2C_SMBUS_BLOCK_MAX at both RECV_LEN sites, the same way i2c-algo-bit does.
In the Linux kernel, the following vulnerability has been resolved: w1: ds28e17: reject an oversize length on an I2C block read w1_f19_i2c_master_transfer() is the master_xfer for the DS28E17 1-Wire to I2C bridge. On an I2C_M_RECV_LEN read, it takes the length from the device. The downstream slave puts a length byte in buf[0]. The driver then reads that many bytes into buf[1] with w1_f19_i2c_read(). buf[0] is controlled by the device and can be 0 to 255. w1_f19_i2c_read() only rejects a zero count. The caller buffer is I2C_SMBUS_BLOCK_MAX + 2, so 34 bytes. A length above 32 makes the read run past it, up to about 222 bytes out of bounds. The SMBus core does check buf[0] against I2C_SMBUS_BLOCK_MAX. That check runs after master_xfer returns. By then the write is already done. i2c-algo-bit rejects an oversize length before it copies, and returns -EPROTO. Reject a length above I2C_SMBUS_BLOCK_MAX at both RECV_LEN sites, the same way i2c-algo-bit does.
In the Linux kernel, the following vulnerability has been resolved: w ...
In the Linux kernel, the following vulnerability has been resolved: w1: ds28e17: reject an oversize length on an I2C block read w1_f19_i2c_master_transfer() is the master_xfer for the DS28E17 1-Wire to I2C bridge. On an I2C_M_RECV_LEN read, it takes the length from the device. The downstream slave puts a length byte in buf[0]. The driver then reads that many bytes into buf[1] with w1_f19_i2c_read(). buf[0] is controlled by the device and can be 0 to 255. w1_f19_i2c_read() only rejects a zero count. The caller buffer is I2C_SMBUS_BLOCK_MAX + 2, so 34 bytes. A length above 32 makes the read run past it, up to about 222 bytes out of bounds. The SMBus core does check buf[0] against I2C_SMBUS_BLOCK_MAX. That check runs after master_xfer returns. By then the write is already done. i2c-algo-bit rejects an oversize length before it copies, and returns -EPROTO. Reject a length above I2C_SMBUS_BLOCK_MAX at both RECV_LEN sites, the same way i2c-algo-bit does.
EPSS
5.5 Medium
CVSS3