Описание
In the Linux kernel, the following vulnerability has been resolved:
serial: 8250: fix possible ISR soft lockup
There are rare cases in which the host gets stuck in the ISR because it
is flooded with messages during the startup phase.
The reason for the soft lockup in the ISR is the missing FIFO error IRQ
(FIFOE) handling. Not handling it and reporting IRQ_HANDLED triggers
the IRQ immediately again.
Fix this by adding a check for the FIFOE status and clearing the FIFO
if no data is ready (DR).
This behavior was observed on an AM62L device which uses the OMAP 8250
driver. Fix it for all 8250 drivers, since the OMAP driver's special
IRQ setup handling may trigger this behavior more frequently, but it
is not ensured that other 8250 drivers aren't affected.
A flaw was found in the Linux kernel's 8250 serial port driver. An attacker communicating over the serial interface can cause a Denial of Service (DoS) by flooding the port with messages during the system startup phase. Due to missing error handling for First-In, First-Out (FIFO) buffer interrupts, the system repeatedly re-triggers the interrupt without clearing it. This results in a continuous loop within the interrupt service routine (ISR), leading to a kernel soft lockup and system unresponsiveness.
Затронутые пакеты
| Платформа | Пакет | Состояние | Рекомендация | Релиз |
|---|---|---|---|---|
| Red Hat Enterprise Linux 10 | kernel | Fix deferred | ||
| Red Hat Enterprise Linux 6 | kernel | Not affected | ||
| Red Hat Enterprise Linux 7 | kernel | Not affected | ||
| Red Hat Enterprise Linux 7 | kernel-rt | Not affected | ||
| Red Hat Enterprise Linux 8 | kernel | Fix deferred | ||
| Red Hat Enterprise Linux 8 | kernel-rt | Fix deferred | ||
| Red Hat Enterprise Linux 9 | kernel | Fix deferred | ||
| Red Hat Enterprise Linux 9 | kernel-rt | Fix deferred | ||
| Red Hat OpenShift Container Platform 4 | openshift/ose-rhel-coreos-8 | Fix deferred | ||
| Red Hat OpenShift Container Platform 4 | openshift/ose-rhel-coreos-9 | Fix deferred |
Показывать по
Дополнительная информация
Статус:
EPSS
5.5 Medium
CVSS3
Связанные уязвимости
In the Linux kernel, the following vulnerability has been resolved: serial: 8250: fix possible ISR soft lockup There are rare cases in which the host gets stuck in the ISR because it is flooded with messages during the startup phase. The reason for the soft lockup in the ISR is the missing FIFO error IRQ (FIFOE) handling. Not handling it and reporting IRQ_HANDLED triggers the IRQ immediately again. Fix this by adding a check for the FIFOE status and clearing the FIFO if no data is ready (DR). This behavior was observed on an AM62L device which uses the OMAP 8250 driver. Fix it for all 8250 drivers, since the OMAP driver's special IRQ setup handling may trigger this behavior more frequently, but it is not ensured that other 8250 drivers aren't affected.
In the Linux kernel, the following vulnerability has been resolved: serial: 8250: fix possible ISR soft lockup There are rare cases in which the host gets stuck in the ISR because it is flooded with messages during the startup phase. The reason for the soft lockup in the ISR is the missing FIFO error IRQ (FIFOE) handling. Not handling it and reporting IRQ_HANDLED triggers the IRQ immediately again. Fix this by adding a check for the FIFOE status and clearing the FIFO if no data is ready (DR). This behavior was observed on an AM62L device which uses the OMAP 8250 driver. Fix it for all 8250 drivers, since the OMAP driver's special IRQ setup handling may trigger this behavior more frequently, but it is not ensured that other 8250 drivers aren't affected.
In the Linux kernel, the following vulnerability has been resolved: s ...
In the Linux kernel, the following vulnerability has been resolved: serial: 8250: fix possible ISR soft lockup There are rare cases in which the host gets stuck in the ISR because it is flooded with messages during the startup phase. The reason for the soft lockup in the ISR is the missing FIFO error IRQ (FIFOE) handling. Not handling it and reporting IRQ_HANDLED triggers the IRQ immediately again. Fix this by adding a check for the FIFOE status and clearing the FIFO if no data is ready (DR). This behavior was observed on an AM62L device which uses the OMAP 8250 driver. Fix it for all 8250 drivers, since the OMAP driver's special IRQ setup handling may trigger this behavior more frequently, but it is not ensured that other 8250 drivers aren't affected.
EPSS
5.5 Medium
CVSS3