Описание
In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: oa_tc6: Improve the error recovery
When oversubscribed traffic causes lot of buffer overflow errors,
probably due to loss of data chunks, driver fails to find a
data chunk with end_valid bit set, before it runs out of sk buffer
space. As a result, assert is seen during skb_put.
Now, check is made if skb buffer has enough tailroom for the
incoming data before accepting. If there is no room, current
frame is abandoned and it will start looking for a data chunk
with start_valid bit, that is a new frame.
SK buffer allocation error is considered as recoverable error.
rx_buf_overflow flag is too specific and no longer the only
condition this flag is used for. Therefore it is renamed as
wait_until_start_valid. This is more appropriate as this flag
is used to look for the next data chunk with SV bit set, after
failures like buffer overflow, buffer allocation failure, skb pointer
validity besides buffer overflow error.
Not writing to status0 if it reads 0.
A flaw was found in the Linux kernel's OPEN Alliance TC6 (oa_tc6) Ethernet driver. Under heavy or oversubscribed network traffic, missing frame boundaries can cause the driver to append incoming data without verifying that adequate buffer capacity remains. This condition triggers an internal kernel assertion failure, allowing an attacker on the adjacent network to crash the system and cause a Denial of Service (DoS).
Затронутые пакеты
| Платформа | Пакет | Состояние | Рекомендация | Релиз |
|---|---|---|---|---|
| Red Hat Enterprise Linux 10 | kernel | Not affected | ||
| Red Hat Enterprise Linux 6 | kernel | Not affected | ||
| Red Hat Enterprise Linux 7 | kernel | Not affected | ||
| Red Hat Enterprise Linux 7 | kernel-rt | Not affected | ||
| Red Hat Enterprise Linux 8 | kernel | Not affected | ||
| Red Hat Enterprise Linux 8 | kernel-rt | Not affected | ||
| Red Hat Enterprise Linux 9 | kernel | Not affected | ||
| Red Hat Enterprise Linux 9 | kernel-rt | Not affected | ||
| Red Hat OpenShift Container Platform 4 | openshift/ose-rhel-coreos-8 | Not affected | ||
| Red Hat OpenShift Container Platform 4 | openshift/ose-rhel-coreos-9 | Not affected |
Показывать по
Дополнительная информация
Статус:
5.5 Medium
CVSS3
Связанные уязвимости
In the Linux kernel, the following vulnerability has been resolved: net: ethernet: oa_tc6: Improve the error recovery When oversubscribed traffic causes lot of buffer overflow errors, probably due to loss of data chunks, driver fails to find a data chunk with end_valid bit set, before it runs out of sk buffer space. As a result, assert is seen during skb_put. Now, check is made if skb buffer has enough tailroom for the incoming data before accepting. If there is no room, current frame is abandoned and it will start looking for a data chunk with start_valid bit, that is a new frame. SK buffer allocation error is considered as recoverable error. rx_buf_overflow flag is too specific and no longer the only condition this flag is used for. Therefore it is renamed as wait_until_start_valid. This is more appropriate as this flag is used to look for the next data chunk with SV bit set, after failures like buffer overflow, buffer allocation failure, skb pointer validity besides buffer overfl...
In the Linux kernel, the following vulnerability has been resolved: net: ethernet: oa_tc6: Improve the error recovery When oversubscribed traffic causes lot of buffer overflow errors, probably due to loss of data chunks, driver fails to find a data chunk with end_valid bit set, before it runs out of sk buffer space. As a result, assert is seen during skb_put. Now, check is made if skb buffer has enough tailroom for the incoming data before accepting. If there is no room, current frame is abandoned and it will start looking for a data chunk with start_valid bit, that is a new frame. SK buffer allocation error is considered as recoverable error. rx_buf_overflow flag is too specific and no longer the only condition this flag is used for. Therefore it is renamed as wait_until_start_valid. This is more appropriate as this flag is used to look for the next data chunk with SV bit set, after failures like buffer overflow, buffer allocation failure, skb pointer validity besides buffer over
In the Linux kernel, the following vulnerability has been resolved: n ...
In the Linux kernel, the following vulnerability has been resolved: net: ethernet: oa_tc6: Improve the error recovery When oversubscribed traffic causes lot of buffer overflow errors, probably due to loss of data chunks, driver fails to find a data chunk with end_valid bit set, before it runs out of sk buffer space. As a result, assert is seen during skb_put. Now, check is made if skb buffer has enough tailroom for the incoming data before accepting. If there is no room, current frame is abandoned and it will start looking for a data chunk with start_valid bit, that is a new frame. SK buffer allocation error is considered as recoverable error. rx_buf_overflow flag is too specific and no longer the only condition this flag is used for. Therefore it is renamed as wait_until_start_valid. This is more appropriate as this flag is used to look for the next data chunk with SV bit set, after failures like buffer overflow, buffer allocation failure, skb pointer validity besides buffer o...
5.5 Medium
CVSS3