Описание
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_qca: Do not write to the serial port after it is closed
hci_uart_close() closes the serdev port if HCI_QUIRK_NON_PERSISTENT_SETUP
is set (for example, for the WCN399x family). A failed hci_dev_open_sync()
following a successful qca_setup() calls hdev->close() but not
hdev->shutdown(), so the port is closed while power->vregs_on is left true.
qca_serdev_remove() then passes its power->vregs_on test and calls
qca_power_off(), which writes to the closed port unconditionally.
Seen on a WCN3988 by unbinding the driver after a controller failure. The
trace below is from a 7.0.0 based kernel, where qca_power_off() was still
named qca_power_shutdown():
Unable to handle kernel NULL pointer dereference at virtual address
0000000000000038
Call trace:
tty_set_termios+0x50/0x238 (P)
ttyport_set_baudrate+0x84/0xc0
serdev_device_set_baudrate+0x24/0x40
qca_power_shutdown+0x158/0x1fc [hci_uart]
qca_serdev_remove+0x54/0x68 [hci_uart]
serdev_drv_remove+0x1c/0x2c
device_remove+0x4c/0x80
device_release_driver_internal+0x1cc/0x224
device_driver_detach+0x18/0x24
unbind_store+0xb4/0xc0
Check HCI_UART_PROTO_READY, which hci_uart_close() clears in the same place
it closes the port, before writing to it. The regulator disable is left
unconditional so the controller is still powered down.
The dangling serport->tty that turns this into a use-after-free is
addressed in a separate patch.
A flaw was found in the Linux kernel's Qualcomm Bluetooth driver. Under specific error-recovery conditions, unbinding the driver after a device failure causes the system to write data to an already closed serial port. A local user could trigger this condition, resulting in a null-pointer dereference that crashes the system and causes a Denial of Service (DoS).
Затронутые пакеты
| Платформа | Пакет | Состояние | Рекомендация | Релиз |
|---|---|---|---|---|
| Red Hat Enterprise Linux 10 | kernel | Not affected | ||
| Red Hat Enterprise Linux 6 | kernel | Not affected | ||
| Red Hat Enterprise Linux 7 | kernel | Not affected | ||
| Red Hat Enterprise Linux 7 | kernel-rt | Not affected | ||
| Red Hat Enterprise Linux 8 | kernel | Not affected | ||
| Red Hat Enterprise Linux 8 | kernel-rt | Not affected | ||
| Red Hat Enterprise Linux 9 | kernel | Not affected | ||
| Red Hat Enterprise Linux 9 | kernel-rt | Not affected | ||
| Red Hat OpenShift Container Platform 4 | openshift/ose-rhel-coreos-8 | Not affected | ||
| Red Hat OpenShift Container Platform 4 | openshift/ose-rhel-coreos-9 | Not affected |
Показывать по
Дополнительная информация
Статус:
EPSS
5.5 Medium
CVSS3
Связанные уязвимости
In the Linux kernel, the following vulnerability has been resolved: Bluetooth: hci_qca: Do not write to the serial port after it is closed hci_uart_close() closes the serdev port if HCI_QUIRK_NON_PERSISTENT_SETUP is set (for example, for the WCN399x family). A failed hci_dev_open_sync() following a successful qca_setup() calls hdev->close() but not hdev->shutdown(), so the port is closed while power->vregs_on is left true. qca_serdev_remove() then passes its power->vregs_on test and calls qca_power_off(), which writes to the closed port unconditionally. Seen on a WCN3988 by unbinding the driver after a controller failure. The trace below is from a 7.0.0 based kernel, where qca_power_off() was still named qca_power_shutdown(): Unable to handle kernel NULL pointer dereference at virtual address 0000000000000038 Call trace: tty_set_termios+0x50/0x238 (P) ttyport_set_baudrate+0x84/0xc0 serdev_device_set_baudrate+0x24/0x40 qca_power_shutdown+0x158/0x1fc [hci_uart] qca_serdev_remove+0x54/...
In the Linux kernel, the following vulnerability has been resolved: Bluetooth: hci_qca: Do not write to the serial port after it is closed hci_uart_close() closes the serdev port if HCI_QUIRK_NON_PERSISTENT_SETUP is set (for example, for the WCN399x family). A failed hci_dev_open_sync() following a successful qca_setup() calls hdev->close() but not hdev->shutdown(), so the port is closed while power->vregs_on is left true. qca_serdev_remove() then passes its power->vregs_on test and calls qca_power_off(), which writes to the closed port unconditionally. Seen on a WCN3988 by unbinding the driver after a controller failure. The trace below is from a 7.0.0 based kernel, where qca_power_off() was still named qca_power_shutdown(): Unable to handle kernel NULL pointer dereference at virtual address 0000000000000038 Call trace: tty_set_termios+0x50/0x238 (P) ttyport_set_baudrate+0x84/0xc0 serdev_device_set_baudrate+0x24/0x40 qca_power_shutdown+0x158/0x1fc [hci_uart] q
Bluetooth: hci_qca: Do not write to the serial port after it is closed
In the Linux kernel, the following vulnerability has been resolved: B ...
In the Linux kernel, the following vulnerability has been resolved: Bluetooth: hci_qca: Do not write to the serial port after it is closed hci_uart_close() closes the serdev port if HCI_QUIRK_NON_PERSISTENT_SETUP is set (for example, for the WCN399x family). A failed hci_dev_open_sync() following a successful qca_setup() calls hdev->close() but not hdev->shutdown(), so the port is closed while power->vregs_on is left true. qca_serdev_remove() then passes its power->vregs_on test and calls qca_power_off(), which writes to the closed port unconditionally. Seen on a WCN3988 by unbinding the driver after a controller failure. The trace below is from a 7.0.0 based kernel, where qca_power_off() was still named qca_power_shutdown(): Unable to handle kernel NULL pointer dereference at virtual address 0000000000000038 Call trace: tty_set_termios+0x50/0x238 (P) ttyport_set_baudrate+0x84/0xc0 serdev_device_set_baudrate+0x24/0x40 qca_power_shutdown+0x158/0x1fc [hci_uart] ...
EPSS
5.5 Medium
CVSS3