Описание
In the Linux kernel, the following vulnerability has been resolved:
bpf: Avoid soft lockup in __htab_map_lookup_and_delete_batch()
__htab_map_lookup_and_delete_batch() has no rescheduling point. The
batch count bounds how many entries are copied out, not how many
buckets are visited, so one BPF_MAP_LOOKUP_BATCH call can walk the
map end to end. The empty-bucket fast path is worse: it stays inside
a single rcu_read_lock() / bpf_disable_instrumentation() section for
any run of consecutive empty buckets.
That holds up on small maps, but it falls apart at scale. On a
144-CPU arm64 host running a CONFIG_PREEMPT_NONE kernel, periodic
BPF_MAP_LOOKUP_BATCH calls against an LRU hash map with 16,777,216
buckets held a CPU inside the batch op for 77+ seconds and triggered
the soft lockup watchdog.
Commit 75134f16e7dd ("bpf: Add schedule points in batch ops") fixed this
same problem in the generic batch ops, but not in this htab-native path,
which every htab-based hash map variant uses for its lookup[_and_delete]
batch ops.
Complete that fix here. Leave the critical section after 64 consecutive
empty buckets, call cond_resched_tasks_rcu_qs(), and resume at the saved
bucket cursor. No locks are held at that point, and resuming from the
cursor is already the function's behavior for non-empty buckets. Add the
same call to the per-bucket loop after copy_to_user(), where every lock
has been dropped. cond_resched_rcu() is not enough here: sleeping with
bpf_prog_active elevated makes tracing programs on that CPU silently
skip their invocations.
Plain cond_resched() is not enough either. It is a no-op under PREEMPT
and PREEMPT_LAZY, the only models arm64 and x86 have offered since
commit 7dadeaa6e851 ("sched: Further restrict the preemption modes").
It is also never a Tasks RCU quiescent state, in any model: the
reschedule counts as a preemption. The walking task stays a holdout and
stalls every synchronize_rcu_tasks() caller, ftrace and BPF trampoline
teardown included, until the syscall returns [1].
cond_resched_tasks_rcu_qs() is the usual tool for that [2]. It reports
the quiescent state at each yield and still reschedules as
cond_resched() does on PREEMPT_NONE and PREEMPT_VOLUNTARY kernels.
A flaw was found in the Linux kernel's Berkeley Packet Filter (BPF) subsystem. A local user could cause a Denial of Service (DoS) by executing batch lookup or deletion operations on large hash maps. Due to a missing rescheduling check when traversing consecutive empty hash table entries, the kernel can monopolize the processor for prolonged periods without yielding. This issue triggers a soft lockup condition, resulting in system unresponsiveness.
Отчет
Red Hat rates this vulnerability as having a Moderate impact because triggering the denial of service requires high local privileges to create and interact with massive eBPF hash tables, limiting exposure to authorized administrative users. By default on Red Hat Enterprise Linux, unprivileged access to eBPF is restricted, which prevents regular users from initiating batch operations against kernel maps. Although an administrative caller can stall a CPU core by processing millions of empty hash buckets without voluntary rescheduling, the issue does not compromise system integrity or confidentiality.
Затронутые пакеты
| Платформа | Пакет | Состояние | Рекомендация | Релиз |
|---|---|---|---|---|
| Red Hat Enterprise Linux 10 | kernel | Fix deferred | ||
| Red Hat Enterprise Linux 6 | kernel | Not affected | ||
| Red Hat Enterprise Linux 7 | kernel | Not affected | ||
| Red Hat Enterprise Linux 7 | kernel-rt | Not affected | ||
| Red Hat Enterprise Linux 8 | kernel | Fix deferred | ||
| Red Hat Enterprise Linux 8 | kernel-rt | Fix deferred | ||
| Red Hat Enterprise Linux 9 | kernel | Fix deferred | ||
| Red Hat Enterprise Linux 9 | kernel-rt | Fix deferred | ||
| Red Hat OpenShift Container Platform 4 | openshift/ose-rhel-coreos-8 | Fix deferred | ||
| Red Hat OpenShift Container Platform 4 | openshift/ose-rhel-coreos-9 | Fix deferred |
Показывать по
Дополнительная информация
Статус:
EPSS
4.4 Medium
CVSS3
Связанные уязвимости
In the Linux kernel, the following vulnerability has been resolved: bpf: Avoid soft lockup in __htab_map_lookup_and_delete_batch() __htab_map_lookup_and_delete_batch() has no rescheduling point. The batch count bounds how many entries are copied out, not how many buckets are visited, so one BPF_MAP_LOOKUP_BATCH call can walk the map end to end. The empty-bucket fast path is worse: it stays inside a single rcu_read_lock() / bpf_disable_instrumentation() section for any run of consecutive empty buckets. That holds up on small maps, but it falls apart at scale. On a 144-CPU arm64 host running a CONFIG_PREEMPT_NONE kernel, periodic BPF_MAP_LOOKUP_BATCH calls against an LRU hash map with 16,777,216 buckets held a CPU inside the batch op for 77+ seconds and triggered the soft lockup watchdog. Commit 75134f16e7dd ("bpf: Add schedule points in batch ops") fixed this same problem in the generic batch ops, but not in this htab-native path, which every htab-based hash map variant uses for its ...
In the Linux kernel, the following vulnerability has been resolved: bpf: Avoid soft lockup in __htab_map_lookup_and_delete_batch() __htab_map_lookup_and_delete_batch() has no rescheduling point. The batch count bounds how many entries are copied out, not how many buckets are visited, so one BPF_MAP_LOOKUP_BATCH call can walk the map end to end. The empty-bucket fast path is worse: it stays inside a single rcu_read_lock() / bpf_disable_instrumentation() section for any run of consecutive empty buckets. That holds up on small maps, but it falls apart at scale. On a 144-CPU arm64 host running a CONFIG_PREEMPT_NONE kernel, periodic BPF_MAP_LOOKUP_BATCH calls against an LRU hash map with 16,777,216 buckets held a CPU inside the batch op for 77+ seconds and triggered the soft lockup watchdog. Commit 75134f16e7dd ("bpf: Add schedule points in batch ops") fixed this same problem in the generic batch ops, but not in this htab-native path, which every htab-based hash map variant uses for its
bpf: Avoid soft lockup in __htab_map_lookup_and_delete_batch()
In the Linux kernel, the following vulnerability has been resolved: b ...
In the Linux kernel, the following vulnerability has been resolved: bpf: Avoid soft lockup in __htab_map_lookup_and_delete_batch() __htab_map_lookup_and_delete_batch() has no rescheduling point. The batch count bounds how many entries are copied out, not how many buckets are visited, so one BPF_MAP_LOOKUP_BATCH call can walk the map end to end. The empty-bucket fast path is worse: it stays inside a single rcu_read_lock() / bpf_disable_instrumentation() section for any run of consecutive empty buckets. That holds up on small maps, but it falls apart at scale. On a 144-CPU arm64 host running a CONFIG_PREEMPT_NONE kernel, periodic BPF_MAP_LOOKUP_BATCH calls against an LRU hash map with 16,777,216 buckets held a CPU inside the batch op for 77+ seconds and triggered the soft lockup watchdog. Commit 75134f16e7dd ("bpf: Add schedule points in batch ops") fixed this same problem in the generic batch ops, but not in this htab-native path, which every htab-based hash map variant uses for ...
EPSS
4.4 Medium
CVSS3