Описание
In the Linux kernel, the following vulnerability has been resolved:
scsi: libsas: Fix SMP IO deadlock during HA resume
smp_execute_task_sg() calls pm_runtime_get_sync() on the host before
issuing an SMP command. When that command is itself issued from the HA
resume path, the get_sync() deadlocks: it waits for the ongoing resume
(the device is RPM_RESUMING), while the resume is blocked in
sas_drain_work() waiting for that same SMP IO to complete.
The deadlock needs an expander-attached SATA disk. During
sas_resume_ha() -> sas_drain_work(), DISCE_RESUME -> sas_resume_sata()
-> ata_sas_port_resume() requests ATA_EH_RESET, and the hard reset for
such a disk is done via SMP PHY CONTROL (sas_ata_hard_reset() ->
sas_phy_reset() -> sas_smp_phy_control() ->
smp_execute_task_sg()). Direct-attached SATA resets through
lldd_control_phy() and SSP devices use TMFs, so neither hits this.
Replace the get_sync()/put_sync() pair with
pm_runtime_get_noresume()/pm_runtime_put(). smp_execute_task_sg() only
needs to hold off autosuspend while the SMP is in flight, and it must
not try to resume the host: a sync resume issued from the HA resume path
itself is what deadlocks, and by the time sas_resume_ha() runs, hw_init
has already reinitialized the hardware, so the device is accessible
without one.
The usage reference is still required. Discovery work normally runs
inside an event worker's PM reference, taken at sas_notify_port_event()
notify time and held until the handler has flushed the disco
queue. sas_rediscover_ex_phy() however requeues DISCE_REVALIDATE_DOMAIN
from within the revalidation worker itself, and flush_workqueue() does
not wait for work items queued during execution, so that chained
revalidation runs with no outer PM reference - without the
get_noresume(), its SMP could race autosuspend.
For the BSG path, sas_smp_handler() is the only caller which may find
the host autosuspended: expander SMP requests do not go through any SCSI
device request queue, so nothing else in that path holds the host
awake. Resume it there with pm_runtime_resume_and_get() and check the
result.
A flaw was found in the Linux kernel's libsas subsystem, leading to a denial of service (DoS). When resuming a host adapter connected to an expander-attached storage drive, an internal deadlock condition can occur while executing management commands. A local user can trigger this vulnerability during device power management resume operations to cause an unrecoverable system hang.
Отчет
This vulnerability is rated as Moderate severity because exploitation requires elevated administrative privileges to execute power state changes and is constrained to specialized hardware configurations. In typical enterprise environments, the issue only manifests on hosts equipped with Serial Attached SCSI (SAS) controllers connected to SATA drives through SAS expanders. While a deadlock during host adapter power recovery results in a localized system freeze, it cannot be exploited remotely and does not lead to data loss or confidentiality exposure.
Затронутые пакеты
| Платформа | Пакет | Состояние | Рекомендация | Релиз |
|---|---|---|---|---|
| Red Hat Enterprise Linux 10 | kernel | Fix deferred | ||
| Red Hat Enterprise Linux 6 | kernel | Out of support scope | ||
| Red Hat Enterprise Linux 7 | kernel | Fix deferred | ||
| Red Hat Enterprise Linux 7 | kernel-rt | Fix deferred | ||
| Red Hat Enterprise Linux 8 | kernel | Fix deferred | ||
| Red Hat Enterprise Linux 8 | kernel-rt | Fix deferred | ||
| Red Hat Enterprise Linux 9 | kernel | Fix deferred | ||
| Red Hat Enterprise Linux 9 | kernel-rt | Fix deferred | ||
| Red Hat OpenShift Container Platform 4 | openshift/ose-rhel-coreos-8 | Fix deferred | ||
| Red Hat OpenShift Container Platform 4 | openshift/ose-rhel-coreos-9 | Fix deferred |
Показывать по
Ссылки на источники
Дополнительная информация
Статус:
EPSS
4.1 Medium
CVSS3
Связанные уязвимости
In the Linux kernel, the following vulnerability has been resolved: scsi: libsas: Fix SMP IO deadlock during HA resume smp_execute_task_sg() calls pm_runtime_get_sync() on the host before issuing an SMP command. When that command is itself issued from the HA resume path, the get_sync() deadlocks: it waits for the ongoing resume (the device is RPM_RESUMING), while the resume is blocked in sas_drain_work() waiting for that same SMP IO to complete. The deadlock needs an expander-attached SATA disk. During sas_resume_ha() -> sas_drain_work(), DISCE_RESUME -> sas_resume_sata() -> ata_sas_port_resume() requests ATA_EH_RESET, and the hard reset for such a disk is done via SMP PHY CONTROL (sas_ata_hard_reset() -> sas_phy_reset() -> sas_smp_phy_control() -> smp_execute_task_sg()). Direct-attached SATA resets through lldd_control_phy() and SSP devices use TMFs, so neither hits this. Replace the get_sync()/put_sync() pair with pm_runtime_get_noresume()/pm_runtime_put(). smp_execute_task_sg() o...
In the Linux kernel, the following vulnerability has been resolved: scsi: libsas: Fix SMP IO deadlock during HA resume smp_execute_task_sg() calls pm_runtime_get_sync() on the host before issuing an SMP command. When that command is itself issued from the HA resume path, the get_sync() deadlocks: it waits for the ongoing resume (the device is RPM_RESUMING), while the resume is blocked in sas_drain_work() waiting for that same SMP IO to complete. The deadlock needs an expander-attached SATA disk. During sas_resume_ha() -> sas_drain_work(), DISCE_RESUME -> sas_resume_sata() -> ata_sas_port_resume() requests ATA_EH_RESET, and the hard reset for such a disk is done via SMP PHY CONTROL (sas_ata_hard_reset() -> sas_phy_reset() -> sas_smp_phy_control() -> smp_execute_task_sg()). Direct-attached SATA resets through lldd_control_phy() and SSP devices use TMFs, so neither hits this. Replace the get_sync()/put_sync() pair with pm_runtime_get_noresume()/pm_runtime_put(). smp_execute_task_sg()
In the Linux kernel, the following vulnerability has been resolved: s ...
In the Linux kernel, the following vulnerability has been resolved: scsi: libsas: Fix SMP IO deadlock during HA resume smp_execute_task_sg() calls pm_runtime_get_sync() on the host before issuing an SMP command. When that command is itself issued from the HA resume path, the get_sync() deadlocks: it waits for the ongoing resume (the device is RPM_RESUMING), while the resume is blocked in sas_drain_work() waiting for that same SMP IO to complete. The deadlock needs an expander-attached SATA disk. During sas_resume_ha() -> sas_drain_work(), DISCE_RESUME -> sas_resume_sata() -> ata_sas_port_resume() requests ATA_EH_RESET, and the hard reset for such a disk is done via SMP PHY CONTROL (sas_ata_hard_reset() -> sas_phy_reset() -> sas_smp_phy_control() -> smp_execute_task_sg()). Direct-attached SATA resets through lldd_control_phy() and SSP devices use TMFs, so neither hits this. Replace the get_sync()/put_sync() pair with pm_runtime_get_noresume()/pm_runtime_put(). smp_execute_task_sg...
EPSS
4.1 Medium
CVSS3