In the Linux kernel, the following vulnerability has been resolved: ntfs: fix kmap_local_page() usage in compress Several compressed I/O paths discard the address returned by kmap_local_page() and later access or unmap the page using page_address(). This is invalid for highmem pages, and local mappings must also be unmapped using the address returned by kmap_local_page(). Map each destination page in ntfs_decompress() only while producing the current sub-block. Use memcpy_from_page(), memcpy_to_page(), and memzero_page() for the other page accesses. Remove unnecessary local mappings from ntfs_write_cb(), where pages are accessed through the vmap() mapping.

In the Linux kernel, the following vulnerability has been resolved: ntfs: Fix index_root heap OOB write in ntfs_ir_to_ib() ntfs_ir_to_ib copies all entries from index_root into a freshly allocated index_block_size-byte buffer without verifying that the entries fit in the available space. The entries in index_root may be larger than the usable entry space in the index block. This can cause OOB writes past the end of the allocation. The validator ntfs_index_root_inconsistent() checks that entries are self-consistent within the IR value, but never cross-checks them against index_block_size. There is no bounds check in ntfs_ir_to_ib() before the memcpy. Fixing this at the sink in ntfs_ir_to_ib() since ntfs_index_root_inconsistent() validates the logical consistency of index_root as a structure and a root with large entries is a structurally valid root. The bug is a size conflict of ntfs_ir_to_ib(). Also, the validator is called once per inode load in ntfs_read_locked_inode() while ntf

In the Linux kernel, the following vulnerability has been resolved: ntfs: reject unprivileged writes to reserved $LX* xattrs Reject setxattr of the reserved $LXUID, $LXGID, $LXMOD and $LXDEV names from userspace unless the caller has CAP_SYS_ADMIN.

In the Linux kernel, the following vulnerability has been resolved: ntfs: serialize resident iomap reads with mrec_lock ntfs_read_iomap_begin_resident() walks the MFT record through ntfs_attr_lookup() -> ntfs_attr_find() without taking ni->mrec_lock, while ntfs_attr_record_resize(), ntfs_make_room_for_attr() and ntfs_resident_attr_record_add() memmove() the same base_ni->mrec buffer under that lock. map_mft_record() only takes a reference and does not serialize, so the reader can observe torn attribute length and offset fields while a writer is relocating the records. KCSAN reports the race between the mmap read fault path and both link() and unlink(): BUG: KCSAN: data-race in ntfs_attr_find / ntfs_attr_record_resize write to 0xffff888100af1018 of 4 bytes by task 96 on cpu 1: ntfs_attr_record_resize+0xd2/0x130 ntfs_attr_record_rm+0xad/0x530 ntfs_delete+0x224/0x640 ntfs_unlink+0x14d/0x280 vfs_unlink+0x157/0x520 read to 0xffff888100af1018 of 4 bytes by task 95

In the Linux kernel, the following vulnerability has been resolved: vdpa_sim: fix cleanup after worker creation failure vdpasim_create() leaves vdpasim->worker as an ERR_PTR when kthread_run_worker() fails. The error path then drops the device reference, which releases the partially initialized simulator. vdpasim_free() unconditionally passes the worker pointer to kthread_destroy_worker(), so the ERR_PTR is dereferenced and can trigger a general protection fault. Store the worker error, clear the pointer, and only clean up the worker when it was successfully initialized. Also make the release path tolerate partially initialized objects by guarding virtqueue and IOTLB cleanup, since the same release path can be reached from other initialization failures. I found this bug myself, though the patch was written with AI assistance.

Rejected reason: This CVE ID has been rejected or withdrawn by its CVE Numbering Authority.

In the Linux kernel, the following vulnerability has been resolved: virtio_balloon: quiesce balloon work before device shutdown Commit 8bd2fa086a04 ("virtio: break and reset virtio devices on device_shutdown()") added a generic virtio bus .shutdown handler that breaks and resets every virtio device during device_shutdown(), i.e. on reboot and kexec. virtio_balloon provides no .shutdown of its own, so that generic path runs while the balloon's asynchronous work is still armed. Once the device has been broken, virtqueue_add_inbuf() in virtballoon_free_page_report() returns -EIO and trips its WARN_ON_ONCE(). On a kernel booted with panic_on_warn that turns an ordinary reboot, for example a kexec based upgrade, into a fatal panic in the middle of device_shutdown(), so the machine never reaches the new kernel. Relaxing that single WARN_ON_ONCE() would only hide the symptom: the inflate/deflate and OOM paths do not warn, they call wait_event(vb->acked, ...) and would instead block foreve

In the Linux kernel, the following vulnerability has been resolved: vdpa/mlx5: fix wrong list iterated in add_direct_chain error path In add_direct_chain(), newly allocated direct MR entries are added to the local list 'tmp', which is spliced into mr->head only on success. On the error path, the cleanup loop was incorrectly iterating over mr->head instead of tmp. Fix by iterating over 'tmp' in the err_alloc cleanup path.

In the Linux kernel, the following vulnerability has been resolved: virtio: rtc: time out alarm requests RTC class operations run with rtc_device.ops_lock held. The virtio RTC alarm requests currently wait without a timeout for the device to return their requestq buffers. On surprise removal, virtio-pci marks the virtqueues broken before unregistering the virtio device. If an alarm request is waiting when the device stops responding, viortc_remove() blocks in viortc_class_stop() while trying to acquire ops_lock. The request cannot complete and device removal hangs until the waiting task is signalled. Use the same 60-second timeout as clock read requests for alarm reads, alarm programming, and alarm interrupt enable requests. The existing message reference counting keeps a timed-out request alive until a late response or device teardown.

In the Linux kernel, the following vulnerability has been resolved: rtc: pcf8563: fix clock provider leak on unbind pcf8563_clkout_register_clk() registers the CLKOUT clock provider with of_clk_add_provider(), but nothing ever unwinds it: there is no of_clk_del_provider() call and the driver has no remove callback. Each of_clk_add_provider() allocates a struct of_clk_provider, takes a reference on the OF node and adds an entry to the global of_clk_providers list, none of which is released when the device is unbound. Every bind/unbind (or module reload) therefore leaks a provider structure and an of_node reference. The clock itself is already device-managed (devm_clk_register()); only the provider registration was not. Use devm_of_clk_add_hw_provider() so the provider is removed automatically on unbind. Tie it to the parent i2c device, whose OF node carries the #clock-cells and clock-output-names properties (the RTC class device has no OF node of its own).

In the Linux kernel, the following vulnerability has been resolved: smb: client: fix request buffer leak in smb2_new_read_req() smb2_new_read_req() allocates the request buffer with smb2_plain_req_init() but only publishes it to the caller with *buf = req at the very end of the function. Two error returns sit in between: rc = smb2_plain_req_init(SMB2_READ, io_parms->tcon, server, (void **) &req, total_len); if (rc) return rc; if (server == NULL) return -ECONNABORTED; [...] rdata->mr = smbd_register_mr(server->smbd_conn, &rdata->subreq.io_iter, true, need_invalidate); if (!rdata->mr) return -EAGAIN; On either of them the buffer is neither released nor handed back, so it is leaked. The caller cannot clean up after it: smb2_async_readv() does 'goto out' on a non-zero return, which skips the cifs_small_buf_release(buf) at async_readv_out, and buf has not been assigned at that point in any case. The write path has never had this problem. smb2_as

In the Linux kernel, the following vulnerability has been resolved: irqchip/renesas-rzg2l: Fix loss of interrupt rzg2l_clear_irq_int() and rzg2l_clear_tint_int() perform a read-modify-write on the ISCR/TSCR status registers to clear the bit for the interrupt just handled. Since these registers are write-0-to-clear per bit, this is racy: If another interrupt's status bit gets set between the read and the write, that bit is written back as 0 by the software-constructed value, clearing an interrupt that hasn't been serviced yet and losing it. This can be reproduced by triggering multiple interrupts at once, e.g.: gpioset -c gpiochip0 355=0 353=0 328=0 352=0 Fix this by writing back only the bit being cleared, with all other bits set to 1, instead of read-modify-writing the whole register. Since 1-bits are left unchanged by hardware, concurrently-set status bits for other interrupts are preserved.

In the Linux kernel, the following vulnerability has been resolved: irqchip/ast2700-intc: Avoid allocating in the irq_domain activate() callback The interrupt core calls the irq_domain_activate() callback from __setup_irq() with desc->lock held and interrupts disabled. Both aspeed_intc1_irq_domain_activate() and aspeed_intc0_resolve_route() test a compatible string with fwnode_device_is_compatible(). fwnode_device_is_compatible() invokes fwnode_property_match_string(), which allocates with GFP_KERNEL. That's obviously not possible with interrupts disabled and a raw spinlock held. Both call sites are only ever handed OF nodes, so use of_device_is_compatible() instead: it walks the property in place and does not allocate.

In the Linux kernel, the following vulnerability has been resolved: clk: visconti: Make sure clk_init_data is fully initialized The clk_init_data structure contains several mutually-exclusive members for different methods to specify the possible parents of a clock, prompting drivers to initialize only the members they need. However, not initializing all members may cause subtle issues, which are only exposed when CONFIG_INIT_STACK_ALL_PATTERN or CONFIG_INIT_STACK_NONE is enabled. visconti_clk_register_gate() fills in init.parent_data, and assumes that init.parent_names is NULL. However, the latter in uninitialized, and thus may cause a crash. Make sure all members are fully initialized, to fix such bugs, and to avoid future breakage when converting drivers to a different method for specifying the parents.

In the Linux kernel, the following vulnerability has been resolved: irqchip/gic-v5: Clear per-CPU IRS data on teardown IRS affinity setup publishes an IRS pointer and IAFFID state in the per-CPU data before the remaining IRS initialization can fail. The error path then frees the IRS data without clearing that published state, leaving CPUs associated with freed memory. On initialization failure and normal IRS teardown, clear the per-CPU IRS association by removing the stale pointer to irs_data. Also invalidate the per-CPU IAFFID state for any CPUs that were tied to the IRS before it was freed.

In the Linux kernel, the following vulnerability has been resolved: irqchip/gic-v5: Check get_logical_index() return value in MADT IAFFID parsing In gic_acpi_parse_iaffid() a given MADT GICC entry might not correspond to a logical cpu recognized by the kernel, resulting in the cpu variable initialization to an error value. Currently, the get_logical_index() return value is not checked for failure, which might result in out-of-bounds memory corruption while trying to index a per_cpu variable array. Add a check to evaluate get_logical_index() return value.

The Ditty – Responsive News Tickers, Sliders, and Lists plugin for WordPress is vulnerable to authorization bypass in all versions up to, and including, 3.1.65. This is due to the plugin not properly verifying that a user is authorized to perform an action. This makes it possible for unauthenticated attackers to retrieve the full item content of non-public Dittys — including drafts, pending, scheduled, and disabled entries — by enumerating integer post IDs against the ditty_init AJAX endpoint. Unlike the non-AJAX init() counterpart, init_ajax() does not verify that the requested Ditty has a 'publish' post status before loading and returning its items, allowing content that administrators explicitly withheld from public view to be extracted.

In the Linux kernel, the following vulnerability has been resolved: ALSA: ice1712: Fix the card leak at probe error with the auto-cleanup snd_ice1712_probe() performs multiple initialization steps after snd_card_new(), but directly returns on failures from later steps without releasing the ALSA card, causing resource leaks when probing fails. Use snd_devm_card_new() together with scope-based cleanup via __free(snd_card_unref), and clear the card pointer after successful registration to keep it alive.

In the Linux kernel, the following vulnerability has been resolved: ntfs: fix off-by-one page overflow in ntfs_decompress() The per-token range check in ntfs_decompress() uses if (cb >= cb_sb_end || dp_addr > dp_sb_end) break; so dp_addr == dp_sb_end falls through to the symbol copy `*dp_addr++ = *cb++`, writing one byte past the destination page. Since NTFS_SB_SIZE == PAGE_SIZE the destination is a single page, so the byte lands in the adjacent page, and *dest_ofs is left one past the sub-block end (the later `*dest_ofs &= ~PAGE_MASK` then yields 1, not 0, so the page is never finalized and later sub-blocks keep writing further past it). A corrupted compressed $DATA attribute thus produces a bounded run of out-of-bounds writes when the file is read. Break as soon as dp_addr reaches dp_sb_end; a full sub-block still completes, as its final copy advances dp_addr to exactly dp_sb_end.

In the Linux kernel, the following vulnerability has been resolved: ntfs: validate usa_ofs before preserving the update sequence number When ntfs_mft_record_alloc() reuses a free mft record it reads the old update sequence number straight from the on-disk record: usn = *(__le16 *)((u8 *)m + le16_to_cpu(m->usa_ofs)); Here m points into the raw $MFT page-cache folio, which still holds unvalidated, MST-protected bytes: the folio is read by a plain iomap_read_folio() and neither post_read_mst_fixup() nor ntfs_mft_record_check() has run on it (both work on private copies). m->usa_ofs is therefore an untrusted u16, and a corrupted record can put it past the end of the record so the two-byte read lands outside the folio. Reading such a record while creating a file gives, under KASAN: BUG: KASAN: use-after-free in ntfs_mft_record_alloc+... Read of size 2 at addr ... ntfs_mft_record_alloc -> __ntfs_create -> ntfs_create -> path_openat Only preserve the old update sequence