drivers/net/wireless/rsi/rsi_91x_usb.c in the Linux kernel through 5.2.9 has a Double Free via crafted USB device traffic (which may be remote via usbip or usbredir).

OpenSSL 1.1.1 introduced a rewritten random number generator (RNG). This was intended to include protection in the event of a fork() system call in order to ensure that the parent and child processes did not share the same RNG state. However this protection was not being used in the default case. A partial mitigation for this issue is that the output from a high precision timer is mixed into the RNG state so the likelihood of a parent and child process sharing state is significantly reduced. If an application already calls OPENSSL_init_crypto() explicitly using OPENSSL_INIT_ATFORK then this problem does not occur at all. Fixed in OpenSSL 1.1.1d (Affected 1.1.1-1.1.1c).

Normally in OpenSSL EC groups always have a co-factor present and this is used in side channel resistant code paths. However, in some cases, it is possible to construct a group using explicit parameters (instead of using a named curve). In those cases it is possible that such a group does not have the cofactor present. This can occur even where all the parameters match a known named curve. If such a curve is used then OpenSSL falls back to non-side channel resistant code paths which may result in full key recovery during an ECDSA signature operation. In order to be vulnerable an attacker would have to have the ability to time the creation of a large number of signatures where explicit parameters with no co-factor present are in use by an application using libcrypto. For the avoidance of doubt libssl is not vulnerable because explicit parameters are never used. Fixed in OpenSSL 1.1.1d (Affected 1.1.1-1.1.1c). Fixed in OpenSSL 1.1.0l (Affected 1.1.0-1.1.0k). Fixed in OpenSSL 1.0.2t (A...

ChaCha20-Poly1305 is an AEAD cipher, and requires a unique nonce input for every encryption operation. RFC 7539 specifies that the nonce value (IV) should be 96 bits (12 bytes). OpenSSL allows a variable nonce length and front pads the nonce with 0 bytes if it is less than 12 bytes. However it also incorrectly allows a nonce to be set of up to 16 bytes. In this case only the last 12 bytes are significant and any additional leading bytes are ignored. It is a requirement of using this cipher that nonce values are unique. Messages encrypted using a reused nonce value are susceptible to serious confidentiality and integrity attacks. If an application changes the default nonce length to be longer than 12 bytes and then makes a change to the leading bytes of the nonce expecting the new value to be a new unique nonce then such an application could inadvertently encrypt messages with a reused nonce. Additionally the ignored bytes in a long nonce are not covered by the integrity guarantee of...

An issue was discovered in the Linux kernel before 5.0.9. There is a use-after-free in atalk_proc_exit, related to net/appletalk/atalk_proc.c, net/appletalk/ddp.c, and net/appletalk/sysctl_net_atalk.c.

An issue was discovered in the Linux kernel through 5.2.9. There is a NULL pointer dereference caused by a malicious USB device in the flexcop_usb_probe function in the drivers/media/usb/b2c2/flexcop-usb.c driver.

[REJECTED CVE] An issue was discovered in the Linux kernel through 5.2.9. There is a NULL pointer dereference caused by a malicious USB device in the ath6kl_usb_alloc_urb_from_pipe function in the drivers/net/wireless/ath/ath6kl/usb.c driver.

In the Linux kernel, a certain net/ipv4/tcp_output.c change, which was properly incorporated into 4.16.12, was incorrectly backported to the earlier longterm kernels, introducing a new vulnerability that was potentially more severe than the issue that was intended to be fixed by backporting. Specifically, by adding to a write queue between disconnection and re-connection, a local attacker can trigger multiple use-after-free conditions. This can result in a kernel crash, or potentially in privilege escalation. NOTE: this affects (for example) Linux distributions that use 4.9.x longterm kernels before 4.9.190 or 4.14.x longterm kernels before 4.14.139.

Upon receiving each incoming request header data, Envoy will iterate over existing request headers to verify that the total size of the headers stays below a maximum limit. The implementation in versions 1.10.0 through 1.11.1 for HTTP/1.x traffic and all versions of Envoy for HTTP/2 traffic had O(n^2) performance characteristics. A remote attacker may craft a request that stays below the maximum request header size but consists of many thousands of small headers to consume CPU and result in a denial-of-service attack.

In Envoy through 1.11.1, users may configure a route to match incoming path headers via the libstdc++ regular expression implementation. A remote attacker may send a request with a very long URI to result in a denial of service (memory consumption). This is a related issue to CVE-2019-14993.

The rest-client gem 1.6.10 through 1.6.13 for Ruby, as distributed on RubyGems.org, included a code-execution backdoor inserted by a third party. Versions <=1.6.9 and >=1.6.14 are unaffected.

An issue was discovered in the Linux kernel before 5.1.8. There is a NULL pointer dereference caused by a malicious USB device in the sound/usb/line6/driver.c driver.

An issue was discovered in the Linux kernel before 5.2.8. There is a NULL pointer dereference caused by a malicious USB device in the sound/usb/helper.c (motu_microbookii) driver.

An issue was discovered in the Linux kernel before 5.1.17. There is a NULL pointer dereference caused by a malicious USB device in the sound/usb/line6/pcm.c driver.

An issue was discovered in the Linux kernel before 5.2.1. There is a use-after-free caused by a malicious USB device in the drivers/net/wireless/intersil/p54/p54usb.c driver.

An issue was discovered in the Linux kernel before 5.1.8. There is a NULL pointer dereference caused by a malicious USB device in the drivers/usb/misc/sisusbvga/sisusb.c driver.

An issue was discovered in the Linux kernel before 5.1.8. There is a NULL pointer dereference caused by a malicious USB device in the drivers/media/usb/siano/smsusb.c driver.

An issue was discovered in the Linux kernel before 5.2.3. There is a NULL pointer dereference caused by a malicious USB device in the drivers/media/usb/zr364xx/zr364xx.c driver.

An issue was discovered in the Linux kernel before 5.0.14. There is a NULL pointer dereference caused by a malicious USB device in the drivers/usb/misc/yurex.c driver.

An issue was discovered in the Linux kernel before 5.2.6. There is a use-after-free caused by a malicious USB device in the drivers/media/usb/cpia2/cpia2_usb.c driver.